Belicone
Belicone Belicold
Silicone mold compound is for making durable cold cast rubber molds. (No heat
or vacuum needed) 1:1 ratio 2 part compound can be worked by hand, no other
equipment or release needed. Make a high quality detailed mold in 15 minutes!
1.20 lbs is enough to make many small molds.
Especially for use with PMC - Precious Metal Clay and Art
Clay products.
Your finished mold can be used over and over.
Use Belicold compound to preserve interesting textures for use
on your PMC designs or to make molds of your best designs! Belicone
does not require heat for vulcanization and has 0% shrinkage. It is
self-lubricating and no release agents are needed.
To
capture a texture, mix the two compound parts together in the amount you need, then press any item into it. Allow the compound to set, and
then remove the item. To use your mold, simply press your PMC into the mold
whenever you want to use that texture.
To
make a reusable mold of a finished PMC design, push the finished piece into the prepared Belicold compound and let it set. Please Note:
The trick to reproducing a piece from a mold is to press the green PMC into the
mold, flatten the back and pop the PMC out of the mold right away. Do not let
it dry in the mold. Let your piece dry as usual and fire and finish!
Two-part
Belicold® silicone mold compound cures without
heat and with 0% shrinkage. Knead together equal amounts of each part, press
the compound around your pattern in an unvented mold frame, clamp and cure at
room temperature (a 1"-thick [25mm] frame under pressure cures in 30
minutes). The compound is self-lubricating (no release agents needed) and is
excellent for molding delicate wax originals or master models. •